With the purchase of packard bell by acer please go to our new site at www.acerweb.co.uk |
|
We ship worldwide
Remember to use our shopping cart you need to be in English so to order you cannot use Babel fish To order just click on the translated page please view this in the original language
normally same day turnaround at this link
click here to go to the repair page and you can book it in online
Need help in dismantling your system?
Laptop Schematics and disassembly guides are available at this link
|
Advanced Technology Attachment (ATA), interface and pinouts Hard, drive, install, specifications, for 3.5" drives and cd/atapi devices For laptop 44 pin connector see ATA=AT bus Attachment. Used at the PC, Apple Macintosh and some other computers 40 pin IDC male connector at the controller & peripherals
Advanced Technology Attachment (ATA), is a standard interface for connecting storage devices such as hard disks and CD-ROM drives inside personal computers. Many terms and synonyms for ATA exist, including abbreviations such as IDE, ATAPI, and UDMA. ATA standards only allow cable lengths in the range of 450 to 900 mm, so the technology normally appears as an internal computer storage interface. It provides the most common and the least expensive interface for this application.
Each cable has two or three connectors, one of which plugs into a controller that interfaces with the rest of the computer system. The remaining one or two connectors plug into drives. Parallel ATA cables transfer data 16 or 32 bits at a time. One occasionally finds cables that allow for the connection of three ATA devices onto one IDE channel, but in this case one drive remains read-only The new 80 pin standard and the differences For most of ATA"s history, ribbon cables had 40 wires, but an 80-wire version appeared with the introduction of the Ultra DMA/66 standard. The 80-wire cable provides one ground wire to each signal wire. This reduces the effects of electromagnetic induction between neighboring wires and enables the 66 megabyte per second (MB/s) transfer rate of UDMA4. The faster UDMA5 and UDMA6 standards require 80-conductor cables. This was done to reduce crosstalk. Though the number of wires doubled, the number of connector pins remains the same as on 40-conductor cables. The physical connectors are identical between the two cable types. If two drives attach to a single cable, the configuration generally sees one as a master and the other as a slave. The master drive generally shows up ahead of the slave drive when the computer's operating system enumerates available drives. The master drive arbitrates access to devices on the channel. Because of this, latency-sensitive devices such as early CD-RW drives often benefited from functioning as a master, and each channel must have a master in order to function properly. In cable select the drives automatically configure themselves as master or slave. This is achieved by cutting wire 28 (on 40 wire cables, or wires 56 and 57 on 80 wire cables) between the two HDD/CDROM connectors. Some newer cables have this done internally in the connectors. In this case, the two connectors are of different colours. |
Normally if it shows us online below we will be available on the phones even outside normal hours
Monitoring code
|
|
Contact Information
NOTE: new tel numbers and address
G Bentley ltd
Our new offices and trade counter click for big pic
Send mail to
with questions or comments about this web site.
|
